Pin Art Toy – part 1

31.    Go to edge mode, select one of the top inside edges and hit Loop.  Chamfer with an amount of .05 and 1 segment.

32.    Goto polygon mode, select the bottom polygon, and Align to the Z min of the Plastic Lid.  Now Extrude with a value of 12.5.  Goto edge mode, select one of the lower vertical edges, hit Ring, right click and Convert to Faces.  Extrude the faces with a value of .25

33.    Select the bottom polygon and hit Collapse.  Using the snaps create a sphere at the bottom that matches the diameter of the corner post.  Set the segments to 48.

34.    Convert to editable poly, switch to polygon mode and delete the polygons on the top half of the sphere.  Select Corner Post01, goto vertex mode and select the vertex at the center of the bottom.  Right click and Convert to Face, and delete the bottom polygons.  Now attach the sphere.  Goto Vertex mode, Ctrl + A and weld with a value of .01.

Pages: 1 2 3 4 5 6 7 8 9 10 11